Products

Monitor crankcase vacuum inside your engine to make sure piston rings are sealing properly in the cylinders. Output: 0.5-4.5V Supply: 5V Range: -1...

This connector kit is used with the PRO550 & PRO600 V8 Complete Harness to utilize extra inputs or outputs.

This connector kit is used with the PRO550 & PRO600 V8 Complete Harness to utilize extra inputs or outputs.

This connector kit is used with the PRO550 & PRO600 V8 Complete Harness to utilize extra inputs or outputs.

This connector kit is used with the PRO600 V8 Complete Harness to utilize extra inputs.

This connector kit is used with the PROBIKE B Expansion Harness to utilize extra inputs or outputs.

Fits PS-10B pressure sensor & Precision Turbo shaft speed sensor. PS-10B pinout: 1 - Signal 2 - Ground 3 - 12V Precision Turbo shaft speed se...

Typically used to monitor fuel, oil, and wastegate pressure. *Not compatible with PRO500/PRO600 or other complete FuelTech engine harnesses. Use PS...

Description Typically used to monitor fuel, oil, and wastegate pressure. TECHNICAL DESCRIPTION Output: 0.5-4.5V Supply: 5V Range: 0-150 psi ...

Description Typically used to monitor nitrous bottle and brake pressure. TECHNICAL DESCRIPTION Output: 0.5-4.5V Supply: 5V Range: 0-1500 psi...

Description Typically used for wheelie bar load cells. TECHNICAL DESCRIPTION Output: 0.5-4.5V Supply: 5V Range: 0-3000 psi Thread size: 1/8"...

Typically used to monitor transmission, converter, clutch, and mechanical fuel pressure. Output: 0.5-4.5V Supply: 5V Range: 0-500 psi Thread size:...

Racepak’s 8-magnet driveshaft split collars are used in conjunction with our driveshaft sensor. These collars will pick up driveshaft RPM sooner th...

This adapter harness is used to connect the CAN bus data stream from your FuelTech ECU to the Racepak IQ3S (Street Dash), IQ3D (Drag Dash) or Racep...

The new Universal EFI Interface Module from Racepak streams CAN-based data from aftermarket ECU systems to any Racepak data logger or dash display....

Automotive relay holder for 4 or 5 pin Mini ISO relays (Regular 40A relays) Perfect relay connector to use with the 40A relay with built in fuse (h...

High quality sealed relay which is typically used for ECU, injectors, and coils when building your own harness. One relay required per item being w...

FuelTech's billet remote pressure sensor mounting block is the perfect solution to mount your pressure sensors in one common place, Each port is in...

High quality sealed relay which is typically used for ECU, injectors, and coils when building your own harness. One relay required per item being w...

Use this Sealed Relay Holder to make installation easier when using a Sealed Relay.

Use this Sealed Relay Holder Kit to make installation easier when using a Sealed Relay. Comes with (2) 10-12 GA / (2) 18-20 GA terminals.